Just a fun piece of wall art that you can hang on a wall, door or in a window.

There is a keyhole slot located on the back for easy hanging or double sided tape works well too!

Size:  APX 9.5in x 9.5in  or  240mm x 240mm.  

Feel free to scale up or down.  Please note:  If you scale SMALLER, make sure you don't make the Z height any thinner than it is as it will effect the keyhole slot on the back.

Change the colors around to match your decor!

Have an AMS?  Just add your colors and you are good to go as-is!

No AMS?

If you only have a single color 3D printer, just set up the print to pause/change filament on the following layers:

Start off with your base color. (This is the White layer in my photos) 
pause at layer 22 in your slicer to change your filament to the 2nd layer color (This is Black in my photos)
pause at layer 28 in your slicer to change your filament to the 3rd layer color (This is Red in my photos)
pause at layer 34 in your slicer to change your filament to the 4th layer color (This is Red in my photos)